Cumulus Support

I've just moved my from Cumulus 1 to Cumulus MX and am having an issue with the logging interval
It is set to 10 minutes in Cumulus and also ten minutes through Easyweather.
When computer is off readings are accumulated at 10 minute intervals as expected and when the computer is booted and Cumulus MX runs this data is downloaded and is shown on the charts page being recorded at ten minute intervals................ but if the computer is left running these recording intervals are being logged at 1 minute intervals - far too much data for me.
Any suggestions how to correct it please
Running on Windows 10
Thanks

The one minute graph interval for live data (i.e not read from your logger archive) is what is used on Cumulus MX, regardless of station type. Cumulus 1 was the same.

Sorry, that doesn't really answer your question - I think the answer may be that you can't change it, but wait for somebody like @mcrossley to confirm.

Thanks for response Freddie. Must admit I hadn’t noticed it on C1, but the graphs are not quite so well defined on C1, plus the fact I was running it on a laptop with a much smaller screen at the time.
I’ll check it out

As freddie says that's just the way it works, and C1 was the same, though C1 generated the graph images rather than sending the data to generate them locally.

Thanks for response Mark. Hadn’t noticed it before but I ran C1 on a laptop with 11 inch screen, running mx on a pc with 22inch screen so the minute temperature changes, coupled with not much temperature change through the day meant even small deviations were very visible.